.. incl-config-controller-1-start:

#. Configure the |OAM| interface of controller-1 and specify the
   attached network of "oam".

   The following example configures the |OAM| interface on a physical
   untagged ethernet port, use the |OAM| port name that is applicable
   to your deployment environment, for example eth0:

   .. code-block:: bash

      OAM_IF=<OAM-PORT>
      system host-if-modify controller-1 $OAM_IF -c platform
      system interface-network-assign controller-1 $OAM_IF oam

   To configure a vlan or aggregated ethernet interface, see
   |node-interfaces-index|.

#. The MGMT interface is partially set up by the network install
   procedure; configuring the port used for network install as the MGMT
   port and specifying the attached network of "mgmt".

   Complete the MGMT interface configuration of controller-1 by
   specifying the attached network of "cluster-host".

   ::

      system interface-network-assign controller-1 mgmt0 cluster-host


.. only:: openstack

   *************************************
   OpenStack-specific host configuration
   *************************************

   .. important::

      This step is required only if the |prod-os| application
      (|prefix|-openstack) will be installed.

   **For OpenStack only:** Assign OpenStack host labels to controller-1
   in support of installing the |prefix|-openstack manifest and
   helm-charts later.

   ::

      system host-label-assign controller-1 openstack-control-plane=enabled

.. incl-config-controller-1-end: