c2d2312c1d
Updated Patchset 1 comments Signed-off-by: Juanita-Balaraj <juanita.balaraj@windriver.com> Change-Id: I5b1e3d4e79a328a9d3aa1c496873b98c516ab95f Signed-off-by: Juanita-Balaraj <juanita.balaraj@windriver.com>
79 lines
2.2 KiB
ReStructuredText
79 lines
2.2 KiB
ReStructuredText
|
|
.. wyr1593277734184
|
|
.. _rolling-back-a-software-upgrade-before-the-second-controller-upgrade:
|
|
|
|
=================================================================
|
|
Roll Back a Software Upgrade Before the Second Controller Upgrade
|
|
=================================================================
|
|
|
|
After the first controller is upgraded, you can still perform an in-service
|
|
abort of an upgrade before the second Controller \(controller-0 in the examples
|
|
of this procedure\) has been upgraded. The :command:`system upgrade-abort`
|
|
command can be run from the node that is updated with the latest release and
|
|
has upgraded successfully.
|
|
|
|
.. rubric:: |proc|
|
|
|
|
#. Abort the upgrade with the :command:`upgrade-abort` command.
|
|
|
|
.. code-block:: none
|
|
|
|
$ system upgrade-abort
|
|
|
|
The upgrade state is set to aborting. Once this is executed, there is no
|
|
canceling; the upgrade must be completely aborted.
|
|
|
|
The following states apply when you execute this command.
|
|
|
|
- aborting:
|
|
|
|
- State entered when :command:`system upgrade-abort` is executed
|
|
before upgrading controller-0.
|
|
|
|
- Remain in this state until the abort is completed.
|
|
|
|
#. Make controller-0 active.
|
|
|
|
.. code-block:: none
|
|
|
|
$ system host-swact controller-1
|
|
|
|
If controller-1 was active with the new upgrade release, swacting back to
|
|
controller-0 will switch back to using the previous release databases,
|
|
which were frozen at the time of the swact to controller-1. Any changes to
|
|
the system that were made while controller-1 was active will be lost.
|
|
|
|
#. Lock and downgrade controller-1.
|
|
|
|
.. code-block:: none
|
|
|
|
$ system host-lock controller-1
|
|
$ system host-downgrade controller-1
|
|
|
|
The host is re-installed with the previous release load.
|
|
|
|
.. note::
|
|
The downgrade process will take a minimum of 20 to 30 minutes to
|
|
complete.
|
|
|
|
You can view the downgrade progress on controller-1 using the
|
|
serial console.
|
|
|
|
#. Unlock controller-1.
|
|
|
|
.. code-block:: none
|
|
|
|
$ system host-unlock controller-1
|
|
|
|
#. Complete the upgrade.
|
|
|
|
.. code-block:: none
|
|
|
|
$ system upgrade-complete
|
|
|
|
#. Delete the newer upgrade release that has been aborted.
|
|
|
|
.. code-block:: none
|
|
|
|
$ system load-delete <loadID>
|